Cut a piece of fabric a bit larger than the pattern, at least 8” x 10”. Find the approximate center of the pattern by following the small black arrows on the edge of the pattern grid. You can fold the paper both vertically and horizontally or mark the center with a pen. Then find the approximate center of the fabric by folding the same way and leaving a deep crease in the center. This method is called counted cross-stitch, as you literally count the squares in the material and replicate the pattern. Plan to begin stitching something that's near the center of the pattern. Working this way (from the center out) will ensure that you don't stitch right off the material.
Find the stitches closest to the center and start with that color of floss. Cut a strand that is roughly 18 to 20 inches long. DMC floss is six-strand: Roll the floss between your fingers and you'll see that what looks like one piece of floss is actually six smaller strands. Use only two strands at a time. This is SUPER IMPORTANT! Otherwise your stitching will be way too bulky. This pattern is very simple and almost always requires only the basic "X" stitch. You may see straight lines in the design — stitch those exactly as they are on the chart. They're like half-stitches. To begin stitching: Either tie a very small knot in one end or leave a short tail and make the first stitches over it to hold it flat. Bring the threaded needle up from the back of the fabric. Relax as you stitch; stitches should lie flat and not distort the fabric.
There are two methods to stitching. When you’re just starting out, you’ll probably want to stitch each X one at a time. When you become more comfortable, you can eventually work a row of half stitches (/ / / /), then work backward to complete the Xs. This method is easier to do without a hoop. So just keep it simple at first until you get the hang of it. The main thing is that each X crosses in the same direction. That is, the top thread of the X should always slant in the same direction. It doesn't matter which way they slant, but if they're mixed, the finished piece will look uneven.
Here is an example of the back side of some stitched pieces. Don’t worry about what the back looks like because life is too short and, once you put it in a frame, no one will ever know. If you choose to secure the thread on the back with knots, make sure they are very tiny or they may look lumpy from the front.
It's a good idea to wash the finished piece, though not absolutely necessary. Hand-wash it in some cold water in the sink with a tiny touch of Woolite or very diluted detergent. Let it dry fully then press it with lots of steam. Be careful not to scorch during the final iron. If it does scorch, don't despair — it will usually disappear when washed again if it's the color of toast and the fabric isn't damaged.
To finish, use Stitchery Tape — it's the best. You can find it in the supplies section of the Subversive Cross Stitch website. It's made specifically for this purpose and is acid-free, archival-quality adhesive — in case you accidentally create an heirloom.
The main thing is to enjoy the delicious thrill of embroidering smart-alecky messages in the last place people expect to see them. Don't worry about perfection, enjoy the ride! When you're done, share your work with the Subversive Cross Stitch group. Additional stitching done by Melissa King and Marshall Thompson.