DIY Network

How to Close Off a Doorway and Turn It Into a Solid Wall

Learn how to remove a doorway in a stud or masonry wall.

Excerpted from Do It Yourself Home Improvement

More in Windows Walls and Doors

drywalling interior of wine cellar

Filling in an unwanted doorway can be done with a 2x4 stud frame or with blocks. It is best to fill in a stud wall with studs and a block wall with blocks, because these materials have different reactions to environmental changes, such as fluctuating temperatures or humidity levels. Using wood is easier, and can be done on a block wall if using blocks seems too difficult. But because the materials used do not match, cracks may later appear at or near the position of the old doorway. These can be filled and painted, but may reappear. By using matching materials, you reduce the risk of having these settlement or movement cracks appear.

Preparing the Area

- Remove the old door, casing and door jamb before starting work on the wall. Lift a door off its hinges or unscrew them from the doorjamb. Remove the casing and door jamb with a claw hammer or pry bar.
- When removing old woodwork, try to keep damage to the surrounding wall to a minimum. It will greatly reduce the amount of finishing work at the end of the project.

Using Studs

Use lengths of 2x4 lumber to line the doorway. In a block wall, use wall plugs and masonry screws to attach the studs to the blocks. In a stud wall, simply attach the new studwork to existing studs with wood screws. Insert more studs and blocking, to strengthen the frame: depending on the dimensions, a central stud and two blockings may be sufficient. Cut some square-edged drywall to fit the gap, and attach it to the wooden frame. Tape the joint between the new drywall and the surrounding wall with self-adhesive tape, and apply joint compound, feathering in the seam between the new and the old wall surfaces.

Using Wood to Fill
This method is easier than using blocks. It is normally used in a stud wall, but can also be used in a block wall. Both wall types are shown here:

Courtesy of © 2007 Dorling Kindersley Limited

Finishing Off

When the joint compound has dried, sand it to a smooth finish. Fill any holes with an all-purpose filler, and sand again, if you wish to for the smoothest possible finish. Attach new baseboard that is the same profile as the rest of the room. You can either use a short section to fill in the gap and match the adjoining boards, or replace the baseboard along the whole wall.

Using Blocks

Blocks can be laid in the opening, using screw-in ties to secure them to the existing blocks, or you can remove blocks at alternate levels from either side of the opening, in which case the new blocks will automatically be securely attached to the existing wall.

Once the wall has dried, remove any loose material before attaching drywall panels and feathering in the edges with the existing wall edge. When the joint compound has dried, sand it, paying particular attention to the seam between the old compound and the new. Decorate, and attach a piece of baseboard across the old doorway, or replace the full length.

Using Wall Ties
Build a small block wall. Match the depths of mortar beds to those on the existing wall, so that wall ties inserted in the old wall's mortar align with the new mortar courses. The blocks will not be an exact fit across the doorway: work out where cuts will be needed.

Courtesy of © 2007 Dorling Kindersley Limited

Removing Half-Blocks
This method takes longer than the wall-tie one. Use a club hammer and bolster chisel to take out half-blocks from the edge of the doorway. Chip away any hardened mortar. Then insert new blocks. If they are not an exact fit, make cuts, or add slightly more mortar, to fill the space appropriately.

Courtesy of © 2007 Dorling Kindersley Limited

Excerpted from Do It Yourself Home Improvement

© Dorling Kindersley Limited 2009

Advertisement