Introduction

Metal stud walls are a good interior wall option. They are not susceptible to rotting and warping or termite damage. Studs are typically pre-drilled to accommodate plumbing and electric. Measure the length of the wall in feet, multiply this number by two and divide by 10 for the number of lengths you'll need for the top and bottom tracks. To determine the number of studs necessary, divide the wall's length by the length of the stud intervals, then add one extra.

Step 1

Build a Layout

Lay out the location of wall on the floor using a measuring tape and pencil (image 1). Use a plumb bob to mark three corresponding ceiling locations for the metal track (image 2). Lay out the top track of the metal wall using a chalk line. Pull the string line across the marks just made (image 3). Measure, mark, and cut the top and bottom tracks. Cut out any sections from the bottom track for door openings (image 4).

Step 2

Install Outer Frame

Attach the bottom track to the floor (image 1). Mark the stud locations at 16-inch intervals on center on both the bottom and top track. To help increase accuracy, place the bottom and top track parallel with each other while marking the stud locations with a felt marker (image 2). Align the top track with the chalk lines made on the ceiling (image 3). Attach the top track to the ceiling using fasteners. Use a plumb bob to mark the top track for the metal stud positions. Insert the studs into the metal tracks. It is easier to insert them perpendicular to their final position (image 4). Using a twisting motion, move the metal studs into position (image 5). Make sure all of the flanges are facing the same direction.

Step 3

Install Studs

Clamp the metal studs to the tracks, making sure the stud is plumb, then using screws, attach each stud to the top and bottom tracks (image 1). After the screw is in place, use a level to check for plumb before installing the next stud (image 2). Use a tape measure to check measurements for the metal studs along the top and bottom track, making sure they are 16 inches apart on center (image 3). Hold the last stud in place with a clamp, aligning the stud with the end of the bottom and top tracks, and secure in place (image 4).

Step 4

Bridge Header

For doorways and windows, you will need to bridge the header. To make the piece fit with the studs, cut along the creases of the material and bend it back (image 1). Install the header piece with the flat side on top using metal screws (image 2). The end of the flange has a slight lip. Flatten the ends of the horizontal pieces to make a secure connection (image 3).

Step 5

Install Metal Studs to Wood Frame

If you have a wood-framed house, you can still use metal studs to construct new walls in your house (image 1). Metal stud to wood frame connections can be made with drywall screws, as with wood-to-wood connections (image 2). When connecting metal framing members to wood, use the same techniques as previously to wrap the end of the horizontal metal member around the stud (image 3). After you have covered the metal frame with drywall and finished it in paper or paint, use screws to attach any trim (image 4). Nails will not make a connection into metal framing.