DIY Network

Painting Kitchen Cabinets (page 2 of 2)

A new coat of paint can make worn, tired kitchen cabinets look new again. Thorough preparation is the key to a successful repainting project.

More in Kitchen

Watch Video
  • Time

    Weekend

  • Price Range

    $50 - $100

  • Difficulty

    Easy to Moderate

Here's How to Do It:

Step 4: Sand the Surfaces to be Repainted

Watch video of this step.

Lightly sand the doors on all sides and faces (Image 1). Use a wood sanding block to prevent rounding over the wood edges (Image 2). If your repainting project is just a facelift for the cabinets, you don’t need to sand and paint the inside of the cabinets; mask off the interiors with painters’ tape for a clean finish and sand only the front surfaces and visible edges of the cabinet face frames.

When sanding, there is no need to remove all of the old paint if it is sound and well-adhered; just roughen the surface to provide the new paint with a firm, clean base for better adhesion. Pay particular attention to especially worn areas of old finish, which typically get the most use. Also be sure to sand over shiny areas to deglaze any remaining previous finish. Stubborn finishes may require rubbing with denatured alcohol and fine steel wool.

If the old paint is flaking off in places, it indicates the finish did not adhere well to the wood surface. This is typically due to moisture or greasy residue getting under the paint layer or into the wood itself, which can be expected in kitchens. Sand these areas to bare wood and spot-prime with a stain-killing primer/sealer before repainting. Wherever you sand down to bare wood, try to blend or “feather” the edges where the old paint meets the wood so the new paint will lay flat, and the paint edges will not be visible or “telegraph” through the new finish.

Thoroughly vacuum the sanding dust from all surfaces (Image 3). If you have a pneumatic air compressor, use high-pressure air to blow the dust out of crevices or molding details. Wipe down the areas to be painted with a tack cloth to pick up any remaining sanding residue (Image 4).

Step 5: Apply the Primer-Sealer

Watch video of this step.

First, apply an even coat of primer-sealer to all surfaces to ensure a well-bonded finish coat. Primer-sealers also reduce the need to sand and deglaze old finishes before repainting. Another advantage to a primer-sealer is that it provides a good base for semi-gloss, water-based paint. High-gloss enamel paint was once the preferred finish for kitchen cabinets because it resists stains and water and is easily cleaned, but today’s water-based finishes are easier to work with and provide an equally durable finish.

Step 6: Apply the Paint

Watch video of this step.

Start by painting the inside edges and openings of the face frames, then the outer cabinet sides, and finally the face frame fronts. This allows you to work quickly in the less critical areas, and enables you to see and correct any drips or smudges on the most visible areas.

Next, paint the cabinet doors and drawer fronts, along with any separate wood pieces or moldings (Image 1). If these parts have raised or routed features, be sure to flow the paint into crevices and corners, but don’t allow it to accumulate in these spots (Image 2).

Always apply paint in thin, light coats, but be sure to cover all areas. Thin coats leave fewer visible brushstrokes and dry more quickly. Don’t lay the finish on thickly and don’t overwork the brush — too many brush strokes will create air bubbles in the finish, leaving bumps and pits when it dries.

Allow the paint to dry for at least four hours between coats. When dry, resand all surfaces lightly to prepare them for the second coat (Image 3), wipe away all sanding dust with a tack cloth (Image 4), then repaint. Two coats of quality paint are usually all that is necessary, but you may want to add a third coat because kitchen cabinets take lots of punishment from cooking heat and day-to-day use, and wood surfaces need all the protection they can get.

« Previous12Next »

Was this project helpful?

Don't forget: Read comments and leave your own

Advertisement

Projects

COMMENT ON THIS PROJECT

    

Sign in

All fields are required.

E-mail Address:

Password:

Remember me on this computer

Signing in

Please enter your email address and we will send your password

E-mail Address

Your password has been sent and should arrive in your mailbox very soon.

Not a member?

Sign up with DIY Network to share tips with other do-it-yourselfers and comment and ask questions on projects.

It's free and easy.