DIY Network

Blog Cabin

How to Wrap a Ceiling Girder With Wood (page 1 of 2)

Create a country-style look in the kitchen by wrapping ceiling girders in wood.

More in Blog Cabin

  • Time

    Weekend

  • Price Range

    $100 - $250

  • Difficulty

    Moderate

Highlights:

Step 1: Purchase Materials

First determine what kind of wood wrap covering is required. If staining the wrapped girder is the final objective, then clear pine will suffice. If painting the beam is in the plans, a less expensive spruce or white board (with some knots) will work.

How much wood is needed? Measure the length (span) of the beam, from wall to wall. Measure its depth (from the ceiling down to the bottom of the beam) and then measure the bottom width, including the two side cuts of the beam (approximately 3/4" thick each side). Review the shopping list above for the remainder of the needed supplies.

Step 2: Prep for the Girder Wrap

The Blog Cabin 2011 kitchen was designed and remodeled with new hanging wall cabinets, therefore, the cabinets were adjusted downward to accommodate the girder wrap (Image 1).

If you are working around cabinetry, allow 1/4" additional space for the construction adhesive. It might be helpful to remove the wall cabinet first, then reinstall it once the girder wrap is painted or stained. Only a handful of wall screws keep the wall cabinet secure, so it's easy to remove.

In preparation to cut the girder wrap wood, accurate measurements are needed for the span (wall to wall), depth (ceiling to bottom of girder) and bottom width measurement (including the outside cuts).

Using a table saw with an assistant, rip the two side cuts to the depth dimension, which, when attached, is flush with the bottom of the girder.

Rip the bottom to width, which, when attached, will be flush with both outside corners. Pre-cut the side and bottom wood to the span lengths using a circular saw or chop saw and bring the three long pieces into the room for installation (Image 2).

Safety Tip: Always wear safety glasses when cutting or using nail guns.

Step 3: Install Side Cuts One and Two

Install Side Cut #1: Bring the full length side piece up to the girder. Adjust the side cut wood, holding it against the end walls. An assistant will be very helpful in holding and aligning the girder wrap pieces in place while they are attached (Images 1, 2 and 3). If cut correctly it will be flush with the girder bottom while touching the ceiling.

Builder's Tip: Hold a speed square at the bottom of the girder to help keep the side cut flush with the bottom.

Install Side Cut #2: Attach the second side cut, using the nail gun and an assistant for alignment (Image 4).

« Previous12Next »

All About…

More Topics

Advertisement

COMMENT ON THIS PROJECT

    

Sign in

All fields are required.

E-mail Address:

Password:

Remember me on this computer

Signing in

Please enter your email address and we will send your password

E-mail Address

Your password has been sent and should arrive in your mailbox very soon.

Not a member?

Sign up with DIY Network to share tips with other do-it-yourselfers and comment and ask questions on projects.

It's free and easy.