DIY Network

How to Sand a Hardwood Floor (page 1 of 2)

Before you refinish an old hardwood floor, you'll need to remove the old coats of varnish. Learn how to sand hardwood flooring using three types of sanders.
Excerpted from Do It Yourself Home Improvement

More in Floors

Step-by-Step Instructions:

Prepare the Room

Order of Work
The direction of sanding will depend on the floor's condition. If it is fairly flat, it may be possible simply to use the sander up and down the boards' grain. If the floor is uneven, or has a very thick coating of paint or varnish, start across the grain. Sanding at a right angle to boards may damage them, so sand at 45 degrees. Cross the room in one direction, then the other before finishing along the grain. Reduce the coarseness of the sandpaper as you progress, finishing with the finest grade.

Protecting Yourself and Your Home
Sanding is a very dusty, noisy and messy job. Wear protective clothing, including ear protectors and a respiratory mask. Cover and mask around doors to prevent dust from spreading throughout the house (image 1). Open all windows, so that you work in a well-ventilated room.

Sanders
You need three sanders: a heavy-duty drum sander (a drum wrapped in sandpaper that rotates at high speed) (image 2); a heavy-duty edging sander (image 3) and a corner sander (image 4). Each requires sandpaper in a particular shape, which is available from the rental store. The paper is expensive and will tear if it is not correctly fitted. Make sure nails do not protrude from the floor. Unplug the sander before changing paper, and allow it to cool if any parts have heated up while in use.

Prep the Floor

Nail down any loose floorboards (image 1). Set the nail heads beneath the surface. Check the floor for protruding nail or screw heads. If any are sticking out, drive them below the surface (image 2).

The Drum Sander

With the sander unplugged, unscrew the retaining strip on the drum sander and feed a sheet of sandpaper underneath it (image 1). Feed the sandpaper around the drum and secure the end under the retaining strip, aligning the cut sections with the retaining screws (image 2). Check that the paper is taut and correctly positioned before you tighten the retaining screws (image 3). Plug in the sander, tilt it backward so that the drum is raised off the floor, and start the machine (image 4).

Using the Drum Sander

Lower the drum onto the floor and make the first diagonal run across the floor (image 1). Sand the whole floor in one direction. Then change direction and make the other set of diagonal runs across the floor, at a right angle to the first runs (image 2). Then change direction again, and run the drum sander across the floor following the direction of the grain (image 3).

« Previous12Next »

All About…

More Topics

Excerpted from Do It Yourself Home Improvement

© Dorling Kindersley Limited 2009

Advertisement

Projects

COMMENT ON THIS PROJECT

    

Sign in

All fields are required.

E-mail Address:

Password:

Remember me on this computer

Signing in

Please enter your email address and we will send your password

E-mail Address

Your password has been sent and should arrive in your mailbox very soon.

Not a member?

Sign up with DIY Network to share tips with other do-it-yourselfers and comment and ask questions on projects.

It's free and easy.