DIY Network

Problem Solvers

How to Repair Wood Furniture That Has Been Chewed By a Pet (page 1 of 2)

Did Fido leave chew marks on the legs of your dining room chair? These instructions will show you how to patch and repair chew marks on wood furniture.

More in Decorating

  • Time

    Under Half Day

  • Price Range

    $50 - $100

  • Difficulty

    Easy to Moderate

Step-by-Step Instructions:

Dogs sometimes enjoy a good chew on a bone, a toy or a piece of wood. Unfortunately, that piece of wood is sometimes a chair or table leg. Chew marks can ruin the look of the furniture and in some cases its structural integrity. You don't need to be an artist or a professional repairperson to make the furniture look a lot better. We repaired the lower spinals on a set of dining room chairs for little money and a few basic techniques.

Take a Look at the Before

Prep the Damaged Area

Next, "score" the damaged area by cutting small hatch marks diagonally across the chew marks (you can also use "X" type cuts). Hold the utility knife blade as shown in Image 1. It is better not to use the blade in the utility knife holder; you will have a lot more control if you don't. Place masking tape over the end of the blade to make it more comfortable on your fingers. Secure the blade firmly between your thumb and pointer finger, and scrape away any frayed edges of wood that stick out from the surface.

Apply Filler

Follow the manufacturer's instructions for mixing the auto-body filler (we used Bondo brand). You will probably have to do a few applications to build up the area so that it will be flush with the surrounding area. Don't mix too much of the filler at once, as each application will set up and dry in about five minutes. NOTE: Only take on one damaged area at a time. It's best to repeat all the steps on each area that has been chewed.

Auto-body filler is a two-part epoxy. Use a small putty knife to mix it thoroughly (30 seconds) on a paper plate. Once you have enough filler covering the chewed area, let it dry to the touch, but don't wait too long — it should not completely harden or it will be difficult to carve off the excess. Slide a knife blade across the surface to slice off the extra filler and to roughly reshape the area that was damaged. It does not have to be exact; you can sand it down to the final shape.

Sand Smooth

Use 150-grit sandpaper to smooth out the filled area. Blend the edges where the filler meets the non-damaged area. Sand some of the non-damaged area as well to feather it all together. Switch to the finer 220-grit sandpaper to finish it up.

« Previous12Next »

Advertisement

COMMENT ON THIS PROJECT

    

Sign in

All fields are required.

E-mail Address:

Password:

Remember me on this computer

Signing in

Please enter your email address and we will send your password

E-mail Address

Your password has been sent and should arrive in your mailbox very soon.

Not a member?

Sign up with DIY Network to share tips with other do-it-yourselfers and comment and ask questions on projects.

It's free and easy.