DIY Network

Furniture Rehab and Repair

How to Paint and Stencil an Old Wood Table (page 1 of 2)

A dated coffee table with a worn-out finish is transformed into an exciting focal point.

More in Decorating

Red Coffee Table

Step-by-Step Instructions:

Take a Look at the Before and After

How to Find a Piece Worth Refinishing

There are many things to look for in finding a “diamond in the rough” piece of furniture from an estate sale, garage sale or thrift store. Look for the potential in a piece of furniture. This can be broken down into a few categories.
First is function, will it work for you in the way that you are hoping for? If you need a good writing surface /desk, don’t buy something that is too small or too tall or has a warped top just because it is cool: it is important that it fits you and your needs.

Second thing to think about is size. Is the piece going to fit through doors and up the stairs? Measure, measure, measure: if you go out thrifting, bring a tape measure and a quick drawing of the room you are looking to fill, along with some basic measurements. Sometimes (as in a garage sale situation) you need to be quick on the draw, as most people don’t like holding bargains while you go home to measure.

Make sure the piece has good "bones." Look for good structure, how well it is built, how heavy it is, does it wobble when you touch it? Use a little common sense. If it’s falling over, it might be too big a project (although if one leg is loose, a trip to the hardware store might resolve the problem). Also, reupholstering a basic dinning chair can be learned from a book in an afternoon, but doing a whole sofa takes a lot of practice and sewing skills.

Lastly does the piece have good lines? Meaning is it architecturally interesting and does it have proportional qualities from an aesthetic point of view (the bowed legs on our piece caught our eye)? If the piece is “close to cool,” you might be able to alter it into a gem by adding appliques or trim, lengthening or shortening the legs, etc. As a rule, if there isn’t something that initially draws you to the piece, it’s probably not a winner.

Clean the Piece

Use a rag to wipe down the piece with mineral spirits or Murphy’s oil soap. Make sure to remove all dirt and crud from the table.

Scratched table

Make Repairs

There were some dents and damages to the corner of the table, so we used auto body filler (Bondo) to fill in the gaps. Use a razor blade to score the area so that the filler has some roughness to adhere to. On the damaged section, make several small cuts in the wood in a crisscross pattern. Mix the filler according to the manufacturer's instructions and apply liberally to the damaged area. Once it's dry but not totally hard (3 to 5 minutes), use that same razor blade and carve back the corners (don't go too deep). Then use 220-grit sandpaper to get the final shape of the corner. Sanding is better than carving to get the final shape; it offers more control over the finished repair.

Sand the Table

We used 150-grit sandpaper on a palm sander, but it could be done by hand with some elbow grease. Lightly sand the entire table and legs. You do not need to remove all the finish; in fact, it's better just to smooth out the surface layer. Do not try to get to bare wood; you will use less primer if you don't. The goal is to get a smooth surface so that the paint will adhere nicely.

« Previous12Next »

Advertisement

COMMENT ON THIS PROJECT

    

Sign in

All fields are required.

E-mail Address:

Password:

Remember me on this computer

Signing in

Please enter your email address and we will send your password

E-mail Address

Your password has been sent and should arrive in your mailbox very soon.

Not a member?

Sign up with DIY Network to share tips with other do-it-yourselfers and comment and ask questions on projects.

It's free and easy.