More in Remodeling
Begin by taking measurements. Measure 3-1/2" away from the stucco and make a mark. Snap a chalk line over the mark and spray the line liberally with acrylic paint to prevent accidental removal of the line. Use a circular saw with a diamond-tipped blade to cut the concrete, spraying the blade with water to keep it lubricated during the cutting process. Follow the manufacturer’s instructions when changing blades. Use a roller guide along with a straightedge to help cut a perfect line (Image 1). When cutting is complete, drill holes in the concrete; the holes will facilitate the chipping process (Image 2).
Use hammers to begin breaking up the areas between the holes. To break up the area further, use a pickax. With the weep screed (screen device installed in outdoor stucco to allow moisture to drain to the exterior) exposed, it will be able to do its job of letting trapped moisture out from behind the stucco.
If replacing the weep screed is not an option, the solution is to create a new drain for the water to pass through. If installing a new drain is not possible, another option is to create what’s known as a French, or gravel, drain. Dig a trench, directing it away from the area of problem drainage, and fill with gravel; the trench will direct moisture into a more desirable location (Image 1). Add decorative, low-maintenance plants such as horsewhips (Image 2). Cut through the plant root with a knife, separating the foliage into small sections. Plant the sections and cover the soil around the plants with pea gravel for a finished look (Image 3).
One last step to ensure water doesn’t get into the pool deck is to caulk the gap between the brick coping and the lining. Apply a bead of polyurethane Deck-O-Seal over the gap, pushing it into the gap until the surface is level with the old caulking.
Find an area to place the rod where it won't come into contact with underground plumbing or utility company wiring. Use a tree stake driver to drive the rod into the ground. When you’ve gone as far as possible with the driver, use a sledgehammer to drive the rod into the ground until only a small section is left exposed (Image 1). With the rod in place, attach the bond wire to the grounding electrode (Image 2). Now, if any current leaks from the motor, it will go straight into the earth.
All fields are required.
Remember me on this computer
Please enter your email address and we will send your password
Your password has been sent and should arrive in your mailbox very soon.
Sign up with DIY Network to share tips with other do-it-yourselfers and comment and ask questions on projects.
It's free and easy.