DIY Network

How to Build an Outdoor Kitchen Island (page 2 of 2)

This steel-and-stucco island turns the patio into a stylish entertaining space.

More in Outdoors

  • Time

    Several Weekends

  • Price Range

    $1,000 - $2,500

  • Difficulty

    Moderate to Hard

Highlights:

Step 4: Dry-Fit the Granite Tiles

For the countertops we chose granite 1' x 1' tiles. Granite is a popular stone for indoor kitchens, but it's also perfect for the outdoors because it's sturdy and easy to clean. These tiles were pre-beveled on all sides so they can lay right next to each other without grout. This saves time on installation and gives a final look that's closer to a single slab of granite. Ahmed and the crew used bull-nosed tiles that were rounded off on the outside edges. First, lay out all of the tiles. Set a corner piece in place for a guide, giving it about a 1/8" overhang so the stucco will come right up to the edge of the tile. Snap a chalk line following the edge of the corner piece and line up the rest of the tiles against that. Pull measurements for the missing gaps so you can cut tiles to fit these holes. Use a wet saw to cut the tiles according to your measurements and set the new tiles out in the sun to dry. The adhesive won't stick to wet tiles. When ordering tile, always order at least 15 percent more than the measurements suggest to cover for cuts and breakage. Since granite is a natural stone, there can be slight differences in color from batch to batch. It's best to order all the tile at one time to keep colors consistent.

Step 5: Attach the Tiles

Use a strong tile adhesive to glue the tiles directly to the cement board. Once you complete sections of tile, weigh them down with something heavy — like bricks — until the adhesive sets.

Step 6: Prepare the Stucco Surface

Before any stucco is attached, install a "weep screed" — a piece of aluminum shaped like an "L" — along the bottom edge of the island. It provides a shelf for the stucco and also directs water away from the island to prevent rotting. Next, use screws to attach metal lath, a wire mesh, over all of the exposed cement board.

Step 7: Apply the Stucco

Prepare the stucco mix according to the directions and apply it quickly to the metal lath with a trowel. This project used one-coat stucco, which is easy to work with and quicker to apply than traditional stucco that takes two coats. Apply the stucco in an upward motion, pushing it into the lath and completely covering it. Don't overwork it. Instead, try to apply each scoop in one motion. After applying a large section of the stucco, mist the whole area to prevent it from curing too fast, which could cause it to crack. Covering the fresh stucco with plastic also helps slow down the curing process. If the stucco does crack, it's easy to repair with a product specifically meant for stucco crack repair; simply apply it with the same technique used with the stucco. Once the stucco has completely dried, paint as desired.

« Previous12Next »

DIY Experts

Yard Crashers

Transform your landscape with host Ahmed Hassan.

Tune in:

MON

9 | 8C

Full Schedule

Was this project helpful?

Don't forget: Read comments and leave your own

Advertisement

Resources

  • Steel island frames from Fresco Frames

COMMENT ON THIS PROJECT

    

Sign in

All fields are required.

E-mail Address:

Password:

Remember me on this computer

Signing in

Please enter your email address and we will send your password

E-mail Address

Your password has been sent and should arrive in your mailbox very soon.

Not a member?

Sign up with DIY Network to share tips with other do-it-yourselfers and comment and ask questions on projects.

It's free and easy.