DIY Network

Art Deco Bath: Demolition and Underlayment

Use these step-by-step instructions to complete the bathroom demolition and put down the underlayment.

More in Remodeling

  • Time

    Several Weekends

  • Price Range

    $500 - $1,000

  • Difficulty

    Moderate

Highlights:

Step 1: Remove the Loose Felt and Glue

The loose felt and glue that is left behind needs to be removed. A heat gun and scraper work great here (Image 1).

Note: Don't overheat the tile, you just want it to bubble -- just loosen the glue.

A slam scraper is also called a stand-up scraper (Image 2) and rents for $15 a day. Be careful because it is a sharp tool.

Tip: It is a good idea to rent a dumpster when you are doing a remodeling project. You can rent a 6-yard dumpster for less than $200.

Step 2: Measure and Cut the Cement Board

Dry fit the cement board before you lay down the thinset and screw it in place.

If any wood on the floor looks stained (this is common around the tub), you can check it with a screwdriver. If the screwdriver does not go through the wood, it is OK. If any wood is rotted out, you would need to replace the wood before you put down the cement board.

After taking careful measurements around the room, cut the 1/2" thick cement board with a circular saw with a carbide blade. Work slowly, don't force the saw through the material, and let the blade do the work.

Note: The cement board must be fully supported, so it doesn't break as you finish your cut.

To cut holes or make notches, use a jigsaw with a carbide blade. Again, work slowly and let the blade do the work.

use jigsaw with carbide blade to cut notches

Step 3: Mix the Thinset

After you have all your boards cut, lay them loosely on the floor first to make sure they fit before you glue them down with thinset.

Use a heavy-duty, low speed drill with a mixing paddle to prepare the thinset. Mix it until it is creamy.

Note: You can rent a drill for approximately $26 a day.

Step 4: Apply the Thinset and Secure the Boards

Apply the thinset with a 1/4" x 1/4" square notched trowel. This provides a heavy application that will give you good adhesion.

Start laying down the cement board, working your way out of the room.

Note: Cement board is always used under ceramic tile because it is stable, even when it is exposed to moisture in a bathroom.

Fasten the cement boards with 1-1/2" galvanized deck screws. Drive them in about every 6" to 8".

heavy application of thinset gives good adhesion

DIY Experts

Sweat Equity

Renovate your home with host Amy Matthews.

Tune in:

Wednesdays

10 | 9C

Full Schedule

Was this project helpful?

Don't forget: Read comments and leave your own

Advertisement

Projects

COMMENT ON THIS PROJECT

    

Sign in

All fields are required.

E-mail Address:

Password:

Remember me on this computer

Signing in

Please enter your email address and we will send your password

E-mail Address

Your password has been sent and should arrive in your mailbox very soon.

Not a member?

Sign up with DIY Network to share tips with other do-it-yourselfers and comment and ask questions on projects.

It's free and easy.