Host David Thiel demonstrates a commercially available micro-adjustable miter gauge that increases the accuracy and fit of miter cuts on the table saw.
More in Home Improvement
A stock miter gauge doesn't always fit tightly into the miter slot. A slight left or right shift of the miter gauge inside the slot during a cut can be a cause of imperfect miters. Also, if you pull the miter gauge back to make a deep cut, the miter gauge may lift up out of the slot. This can also cause imperfect miters. Some stock miter gauges only have three preset angles. The markings are set far apart, making it difficult to achieve a precise angle.
Installing a Double Wall Oven (02:54)
LED Glass Countertops (01:21)
Bath Floors (04:01)
Adirondack Chair (00:20:01)
Creative Bathroom Storage Tips (00:01:00)
Modern Wall Sconce (02:21)
Install Hardwood Floor (04:25)
Seashell Wind Chimes (00:03:18)
Two-Tone Harmony (03:35)
Low-Level Deck Footings (00:53)
10 Best Bathroom Remodeling Trends 10 Photos
Insulation and Soundproofing Materials 14 Photos
© 2014 Scripps Networks, LLC. All Rights Reserved.