Use this expert advice to make cutting with a table saw a bit easier.
More in Home Improvement
Another way to achieve a greater angle on the saw is to make a saddle for the fence, then attach an extra piece to it so you can support the board during the cut.
Tip: Use an angle finder to make sure you've obtained the proper angle. If not, adjust the angle of the blade until you're getting the angle you need.
Note: Take extra care when making these cuts. The angle of the blade can cause the board to become pinched between the blade and the fence. Also, the scrap piece can kick back.
Installing a Double Wall Oven (02:54)
LED Glass Countertops (01:21)
Bath Floors (04:01)
Adirondack Chair (00:20:01)
Creative Bathroom Storage Tips (00:01:00)
Modern Wall Sconce (02:21)
Install Hardwood Floor (04:25)
Seashell Wind Chimes (00:03:18)
Two-Tone Harmony (03:35)
Low-Level Deck Footings (00:53)
10 Best Bathroom Remodeling Trends 10 Photos
Insulation and Soundproofing Materials 14 Photos
© 2014 Scripps Networks, LLC. All Rights Reserved.