GARDENING Index
Diseases & Weeds
Flowers
Fruits & Vegetables
General Information
Container Gardening
Insects & Pests
Kids Gardening
Lawns & Landscaping
Plants & Foliage
Public Gardens
Seasons & Zones
Services & Associations
Shrubs & Trees
Soil & Water
Sod
Soil Improve, Composting & Fertilizing
Types
Watering & Irrigation
Other

Structures & Ornaments
Tools
Water Gardening
Wildlife

SPONSOR LINKS

  • Master Control Valve Box
  • From "DIY Watering Your Lawn"
    episode DWYL-104
    advertisement

    Click here to view a larger image.

    Figure A

    Click here to view a larger image.

    Figure B

    Click here to view a larger image.

    Figure C

    Click here to view a larger image.

    Figure D

    Click here to view a larger image.

    Figure E

    Click here to view a larger image.

    Figure F

    Click here to view a larger image.

    Figure G

    Now that the backflow preventer is in place, it's time to install the valve box and start connecting the zone valves. Different codes require different types of installation, so check to find out what is required in your area. This demonstration is for installing the box below the ground.

    Installing the Valve Box

    1. Slip the master control valve box over the backflow prevention device and master valve (figure A). The goal is to have the lid of the box flush with the ground, so add or remove dirt as needed.

    2. Place the lid upside down on the valve box (so it's easy to grab onto) and backfill (figure B) until the dirt is placed firmly around the valve box (figure C). You'll come back later and wire the master valve after the zone valves have been installed and wired.

    Dividing the Lawn into Circuit Zones

    Since all the sprinklers can't run simultaneously (because the water pressure would not be sufficient), it's necessary to divide the lawn into circuit zones. Each of these circuit zones will operate independently. In our case, our lawn is divided into four circuit zones: Zone 1 (figure D) will water the right side of the lawn; Zone 2 (figure E) the left side; Zone 3 (figure F) the smaller area of lawn by the sidewalk; and Zone 4 (figure G) the shrub and flowerbeds by the house. Each of these four zones will require a separate valve box.

    Installing a Zone Valve

    1. Dig a hole about 14" deep and 14" wide.

    2. Attach the electronic valve to a short piece of poly pipe using stainless-steel clamps. (Use two clamps for extra tightness.)

    3. Slide two clamps over the end of the main pipe.

    4. Attach coupler into the end of the short pipe and into the end of the main line.

    5. Crimp tightly using two stainless-steel clamps.

    6. Place valve box in hole and level, making sure the lid is flush to the ground.

    7. Backfill the dirt around the box and pack tightly. The wiring of the valves will be done after all of the valves and boxes have been installed.


    RESOURCES :
    Cottage Water Systems: An Out-Of-The City Guide to Pumps, Plumbing, Water Purification, and Privies
    Model: 096969220X
    Author: Max Burns

    Cottage Life Books

    Handbook of Water Use and Conservation: Homes, Landscapes, Industries, Businesses, Farms
    Model: 1931579075
    Author: Amy Vickers
    (2001)

    To order this title from Amazon.com, click here.


    WaterPlow Press
    Website: www.waterplowpress.com


    GUESTS :
    Chuck Coddington
    Coddington Enterprise
    6376 Fairview Road
    Hixon, TN 37343
    Phone: 423-847-9964
    Home Irrigation Specialist

  • ALSO IN THIS EPISODE: