DIY Network

Find show schedules
for DIY Network

Get DIY | Shows List

SHOW HIGHLIGHTS

HOST BIOS:

Carol Duvall

ON TV NOW

Visit the Program Guide to see what's on air now.

Find an Episode

Episode Topic

Or was shown during

See what's on DIY

DIY Shows A-Z
(a listing of all shows)

Rusty Mica Luminaria

From "Carol Duvall Show"
episode CDS-1519F

Project by Monica Heeren.

Materials

Shellac Bond mica sheet
Sophisticated Finishes rust antiquing kit
design drawing
glass votive cup
candle
heat gun
straight glass or empty soup can
old potholder
paint brush
glue
ruler
craft knife

Figure A

Figure B

Figure C

Figure D

Figure E

Figure F

alternative design

Steps:

1. Measure and cut mica into two pieces: 4-1/2" x 9" and 4-1/2" x 2".

2. Place your design under the mica and paint the silhouette using step one of the rust paint kit (Iron Metallic Surfacer) (figure A).

3. Paint a 1/8-inch trim on all edges of mica, front and back. Let dry.

4. Heat the large piece of mica with a heat gun and slowly mold it around the water glass or soup can (figure B). Use an old potholder to protect your hands and to help ease the mica into shape (figure C).

5. Apply a liberal amount of glue to the side edges of the 4-1/2" x 2" piece of mica (figure D).

6. Position mica within the curve of the molded piece of mica, closing the off the opening (figure E). Let dry in face down position.

7. With a paint brush, apply step two of the rust kit (Rust Antiquing Solution) to all previously painted areas on the mica (figure F). Let dry. The rusting will begin and continue over the next eight to 48 hours.

8. Set a glass votive holder and candle within the luminaria, light and enjoy.

RESOURCES :
Sophisticated Finishes Rust Antiquing set
Modern Options Inc.
Website: www.modernoptions.com

Shellac-bond Mica Sheets
Two Crafty Ladies
We apologize no contact information is available.

GUESTS :
Monica Heeren
Designer
We apologize no contact information is available.