SHOW HIGHLIGHTS
HOST BIOS:
Carol Duvall

ON TV NOW
Visit the Program Guide to see what's on air now.
Find an Episode
Episode Topic
Or was shown during

See what's on DIY
DIY Shows A-Z
(a listing of all shows)

  • Patio Lantern Lights
  • From "Carol Duvall Show"
    episode CDS-1265
    advertisement

    Click here to view a larger image.

    Click here to view a larger image.

    Figure A

    Click here to view a larger image.

    Figure B

    Click here to view a larger image.

    Figure C

    Click here to view a larger image.

    Figure D

    Click here to view a larger image.

    Figure E

    Click here to view a larger image.

    Figure F

    Click here to view a larger image.

    Figure G

    Click here to view a larger image.

    Figure H

    Maryse Carrier designed these charming lanterns, which can be made a perfect match for weddings, showers and garden parties. Or, at a party, have each guest make a box and create a cooperative garland.

    Materials

    strand of small white lights with white wiring
    assorted flat, die-cut boxes*
    rubber stamps
    6" saucer or compass
    pigment inks
    Maruyama paper or vellum
    craft knife
    cutting mat
    double-sided tape

    *Count the number of lights on the garland and divide by two. This is how many finished boxes you will need.

    Steps:

    1. Cut a 1/2" cross in the bottom of a box. This will be the top of the lantern where the light will be popped through.

    Note: Don't make the initial cross too big or the box will fall off the set of lights. You can always make it larger if needed.

    2. Cut all extra pieces that might show through the vellum or Maruyama paper (figure A).

    3. Mask off the box tabs using sticky notes (figure B). Color the entire box by rubbing on the pigment-based inks. Strokes can vary: light or dark, straight or curved, etc.

    4. Stamp the image, remembering to chose solid, thicker designs that can be cut out to let light pass through (figure C).

    5. Cut some areas out, remembering not to approach edges too closely or the box will collapse (figure D).

    6. Turn the box over right side down and add pieces of Maruyama or vellum to the inside with double-sided tape (figure E).

    7. Cut strips of tissue paper using a paper cutter. Place a piece of cardboard against the paper cutter blade to hold the tissue in place. Fold the tissue paper strips in half and hold them together with tape.

    8. Hot glue the end of the streamers to the inside of the box next to the "X" that was cut for the lights so that they hang down beneath the light (figure F) .

    9. Fold and close the box with double-sided tape and secure it over one of the small bulbs. See figure G for an idea of how the lanterns look with the light shining through.

    10. Make enough boxes to cover every second light. Note: Embellish with beads, wire, ribbons, etc., if desired. Use different sizes and different shapes of boxes on the same garland (figure H).

    Note: Do not leave the paper lantern garlands unattended. Though most small lights do not give out much heat, this is a handmade paper product and one should keep an eye on it.


    RESOURCES :
    rubber stamps, lantern kit, Maruyama paper, Stamping Magenta Style 2 video
    To locate a local retailer or for more information:
    Magenta
    Website: www.magentastyle.com

    pigment inks
    Clearsnap Inc.
    Website: www.clearsnap.com


    GUESTS :
    Maryse Carrier
    designer
    Magenta
    Website: www.magentastyle.com

  • ALSO IN THIS EPISODE: