Project designed by Paulina Tosches. Materials: wooden baby crib
scroll saw
drill
1" thick piece wood (length/width vary)
12-18 wood screws
medium grit sandpaper
latex paints in following colors - cream, plum, green, lemon yellow, pink
2" paintbrush
artist paintbrushes
light oak wood stain
cotton rag
clear spray-on sealer in satin or matte finish Steps: - Dismantle both the headboard and footboard from crib.
- Find center of footboard and saw in half. Sand any rough edges.
- Use a hammer and nail to create a "starter hole" for a screw.
- Attach the footboard halves to sides of the headboard with wood screws along the perimeter to ensure a strong hold.
- Measure the length and width between the two sides where bench seat will be positioned. Saw a 1"-thick piece of plywood per these measurements.
- Attach plywood to sides of bench using wood screws as in steps 3 and 4. Attach one screw to every other rail to ensure strong hold.
- Base-coat bench with cream color using a 2" brush. Allow to dry.
- Using smaller artist brushes, paint roses on bench in various colors. Allow to dry.
- Lightly sand over bench, including the flower design, to create a weathered look.
- Use cotton rag to apply stain to entire crib bench in long strokes. Let dry for 24 hours.
- Spray entire bench with clear sealer.
Tip: Benches can be used to display potted flowers in a patio or garden setting.
GUESTS :
Paulina Tosches
Designer / Artist
Email: yavvo@aol.com
| 
)
