DIY Network

Victorian Expansion: Final Touches With only final touches left, the bathroom is near completion. From "Bathroom Renovations" episode DBTR-413

(Continued from page 1)

Bathtub Fixtures

1. Determine the spout location by measuring from both walls 2-1/2 ".

2. Use a drill with a hole saw attachment to make a hole in the tub deck surface. Place the spout in the hole.

advertisement

	Figure K
	Figure L
	Figure M
	Figure N
	Figure O
	Figure P
	Figure Q

3. From below, place a plastic washer with a rubber seal and thread on the nut. This will get tightened later.

4. Determine the exact placement for the hot/cold faucet valves. Drill relative size holes again with the hole saw attachment.

5. From below, feed up the cold and hot faucet valves. On top, add the rubber washer and thread on the lock nuts (figure K). The finish pieces screw on the nut (figure L).

6. The faucet handles snap down (figure M). Finally, tighten them with an Allen wrench.

Shower Fixtures

1. Place a foam faceplate gasket, which will create the watertight seal on the tile.

2. Slide on the cartridge sleeve and set the faceplate over the stem.

3. There are holes in the diverter to receive the finished, chrome screws. Tighten the screws until the faceplate is flat against the wall.

4. Screw on the lever handle adapter and slide on the lever (figure N).

Sink Fixtures

1. Drop the water supply lines through the pre-drilled hole in the glass vanity top.

2. Add the washers and nut and tighten with a crescent wrench.

3. Finally, attach and tighten the water supply lines with a crescent wrench (figure O).

Washer/Dryer Installation

1. With the water, electrical, venting and draining in place move the washer and dryer into place.

2. Keep the washer and dryer six inches away from the wall to make the final connections.

3. Remove the knock-out seal for the drain.

4. Run the drain hose down into the drain.

5. Connect the water supply lines to and from the washer.

6. Turn the water on, check for leaks and move the washer into place.

7. Hook up the dryer vent (figure P).

8. The finished bathroom is beautiful (figure Q)!

1 | 2

RESOURCES :

M Series Mirrored Bath Cabinets
Model #: MT16D4FPN

Traditional Single Sconce
Model #: MLLTRCR
Website: www.robern.com

Lavatory Console
Model #: 2430T-TNG

Tempered Glass Vessel Sink
Model #: 112T-TNG

Chrome Polished Bottle Trap
Model #: 9100-CP

Chrome Polished Removable Mounting System
Model #: 9031-CP
Website: www.decolav.com

Toilet
Model #: BER-ORA150
Website: www.insidestore.com

Isonzo Two-Handle Kitchen Faucet
Model #: I1-SNSP

Deck Mount with Handshower Faucet
Model #: F3

Single Handle Tub and Shower Faucet
Model #: F4

Towel Ring Bathroom Accessory
Model #: F8

Paper Holder Bathroom Accessory
Model #: F9

Robe Hook Accessory
Model #: F10

Towel Bar Bathroom Accessory
Model #: F7
Website: www.faucet.com

Front Load Washer
Model #: GHW9400P

Front Load Dryer
Model #: GEW9250PL
Website: www.whirlpool.com