DIY Network

Victorian Expansion: Final Touches With only final touches left, the bathroom is near completion. From "Bathroom Renovations" episode DBTR-413

advertisement

	Figure A
	Figure B
	Figure C
	Figure D
	Figure E
	Figure F
	Figure G
	Figure H

Materials:

Mirror/Sconces

drywall saw
work gloves
safety glasses
utility knife
pencil
tape measure
4' level
screw gun
screws

Vanity

hammer
wall anchors
screwdriver
tape measure
4' level
screw gun
pencil

Toilet/Sink

crescent wrench
channel lock wrench

Tub/Shower Fixtures

safety glasses
tape measure
marker
power drill
hole saw attachments
Allen wrench
channel lock wrench
screwdrivers
foam face plate gasket

Washer/Dryer

hammer
flathead screwdriver
channel lock wrench

Mirror and Sconces

1. Determine where to install the mirror (figure A).

2. With a jab saw, cut out and remove dry wall to install cabinet (figure B). Screw it into place (figure C).

3. Measure out on either side of the mirror for the sconces (figure D). Scribe the junction boxes and use a jab saw to remove the drywall for the sconces.

4. With the wires striped, feed them through the junction box and adhere the box to the wall with screws (figure E).

Glass Vanity Installation

1. Assemble the vanity frame using provided instructions and hardware.

2. To make sure the vanity will be center, mark a line on the wall using a level coming off the center of the mirror (figure F).

3. Dry fit the vanity and with a pencil, mark where the screws will go.

4. Remove the vanity and drills holes on the marks for wall studs. Hammer the wall studs into the holes.

5. Fit the vanity back into place and screw it in place (figure G).

Toilet Installation

1. Set the rubber ring to create a watertight seal and to protect the porcelain on both the tank and the bowl. Drop closet bolts into the flange.

2. Set the toilet in place, drop washers over the bolts and thread the nuts down to tighten. Cut the excess bolts with a hacksaw.

3. Install the toilet seat using provided hardware (figure H). Then, hook up the water line.

Sink Installation

1. Place the mounting ring with a rubber between the sink and the glass countertop.

2. Drop the drain stem down into the sink (figure I).

3. Thread the rubber washer up the stem, put the drain nut on and tighten it using a channel lock wrench (figure J).

Figure I

Figure J

Page  1 | 2