DIY Network

Bathtub Installation/Finishing Touches From "Bathroom Renovations" episode DBTR-409

Host Amy Matthews and homeowners install a sleek white and chrome tub. The finishing touches and accent pieces are then put into place. Molly finishes grouting while Paul and Amy install the new light and mirror fixtures.

advertisement

	Figure A
	Figure B
	Figure C
	Figure D
	Figure E
	Figure F
	Figure G
	Figure H
	Figure I
	Figure J
	Figure K

Materials:

Tub

insulation
gloves
safety glasses
Construction Adhesive
1/4"x1/4" square notch trowel
tape measure

Light

wire nuts
screwdriver
light bulbs

Shower Fixture

Teflon tape

Mirror

level
tape measure
marker
drill with masonry bit
mounting brackets and screws
safety Glasses

Bathtub Installation

1. The tub needs to sit on a solid, level surface. If needed, add cement board to make up the height difference (figure A).

2. To minimize sound from the tub motor, stuff insulation in the sides of the tub deck before closing the walls (figure B).

3. Apply construction adhesive with a 1/4" square-notch trowel where the tub will meet the floor (figure C).

4. Place tub in the opening. Measure both ends to ensure a straight, centered fit (figure D).

Light Installation

1. Connect the ground wire from the light to the ground screw (figure E).

2. Connect the other wires with wire nuts.

3. Put in a light bulb to test the fixture before securing it to the wall (figure F).

4. Mount the fixture on the wall with the provided nut caps.

5. Add the globes and light bulbs (figure G).

Shower Fixture Installation

1. Attach escutcheon set for the volume and thermostatic controls (figure H).

2. Wind Teflon tape over the end of the shower arm and screw. Attach the shower head to the shower arm (figure I).

Wall-mount Mirror Installation

1. Mark the location of the screws to hang the mirror.

2. The holes will need to be pre-drilled through the tile. First, tap the screw locations with a nailset to remove the glaze. This will prevent the drill bit from slipping and scratching the tile.

3. Use a drill, on the hammer setting, with a carbide masonry bit to pre-drill the holes (figure J).

4. Attach brackets and hang mirrors (figure K).

RESOURCES :

Bathtub
Forma
Model #: RE 527
Website: www.jasoninternational.com

Water Closet
Model #: 6006.130.01

Martinique Countertop Lavatories
Model #: 1025.000.01

Barrymore Tilting Mirrors
Model #: 2077.250.96
Website: www.stthomascreations.com

Paper Holder
Sonora Collection
Model #: D442231

Robe Hooks
Sonora Collection
Model #: D442171

Towel Bar 24"
Sonora Collection
Model #: D442421

Towel Bar 18"
Sonora Collection
Model #: D442421
Website: www.danze.com