DIY Network

Backsplash/Countertop Grout/Venting Dryer From "Kitchen Renovations" episode DKTN-513

A hammered metal backsplash is installed behind the range. To finish off the countertop, grout is added and the dryer venting is completed.

advertisement

	Screw 2x4s across the backsplash to hold it in place until the adhesive has a chance to dry.
	Let the grout sit for a few minutes then wipe off the excess with a sponge.
	Run a bead of silicone on the vent cap and place in the hole. Secure it with screws.

Materials:

Backsplash

construction adhesive
2x4s
screw gun
screws

Grout

buckets
grout float
sponge

Dryer Vent

stud finder
drywall saw
safety glasses
drill
spade bit
hole saw
silicone
vent cap
flexible duct

Stainless Backsplash Installation

1. Put construction adhesive on the back of the plywood and set the panel in place.

Countertop Grout

1. Mix grout to a peanut butter consistency.

2. Spread grout into seams with a grout float. Hold the float at a 45-degree angle as you work so you do not pull the grout back out of the seams.

3. To remove haze from the tile, wipe with a dry cloth.

Venting Dryer

1. Determine vent placement, locate studs and cut a hole the size of the duct with a drywall saw.

2. Use a spade bit to pilot hole to the exterior of the house, then cut the opening with a hole saw.

3. Set washer and dryer in place and attach the duct to the dryer and vent cap.

RESOURCES :

Re-circulating Vent
Website: www.siriushoods.com

Triflow Faucet
Website: www.frankeksd.com

Backsplash
Website: www.frigodesign.com

Washer, Dryer and Dishwasher
Website: www.askousa.com

Stainless Steel Refrigerator
Website: www.northlandnka.com

Microwave
Website: www.sharpusa.com

Dual-fuel Range
Website: www.aga-ranges.com

Cabinet Hardware, Door Handle
Website: www.amerock.com