Installation of Beadboard CeilingHost Amy Devers offers these instructions for installing your own beadboard ceiling.
- Snap a chalk line on the ceiling 5-1/2" away from the beginning wall running the width of the room.
- Line the first row of boards up with the line, not the wall. This is to insure that you get a straight beginning line.
- On the first board, you must face-nail. This means nailing right into the surface or face of the board.
- Make sure that the ends of the boards are snug for a clean finish.
- For any obstacles such as junction boxes, mark the board, take it down, use a jigsaw to cut the board, then re-install the cut board.
- All boards (after the first board) are nailed through the groove. This is called "blind nailing" All the nail heads are completely hidden when the tongue of the next board slides into the groove.
- To fill the gap between the last board and the wall, take a series of measurements along the gap. Use the narrowest of the measurements to rip the last board.
- Use a flatbar to get the tongue and groove joints to fit tightly.
- Face-nail last strip into place.
- Measure the room for the 1/4" round trim.
- Cut the trim down to size with a miter saw and nail it up with a pneumatic nailer.
- When butting two pieces of trim up to each other, cut opposite 45 degree angles on each end. This is called a scarf joint and gives a seamless transition.
The next challenge tackled by the Campbell family--and the Rescue crew--is the restoration of porch furniture that has definitely seen better times. Host Karl Champley and Sandy Campbell discuss their options for color and finish, then get to work. The two sand the tables down, remove dust and debris, then apply primer to the surface. After the primer has dried, the two begin applying paint.
