When it comes to battling mold, the best thing for homeowners to do is prevention. And the message of this story is that if you can prevent problems from occurring in the first place, you'll save loads of money in the long run. Bob Thompson, an engineer for the Environmental Protection Agency, first encountered mold during a study of schools in the early 1990s. "We went randomly to various parts of the country and observed what was going on relative to radon in schools," he says, "but we noticed that over and over again we were seeing mold in the schools. And quite large amounts of it." But even with the worst-case scenario, simple maintenance could eliminate major problems. Controlling moisture is the key! Doing a Moisture Assessment of Your Home There are essentially two types of moisture: - Vaporous (humidity) or
- Bulk water from sources such as rain and leaking pipes.
Note: Moisture from either source can cause a mold problem. - The first place to check for moisture is the ground near your home. The ground slope is easy to see, but to be sure the moisture is going away and not toward your home, take a bucket of water and pour it near the foundation of your home. Does the moisture stay where it is, move toward your home and away from it? If the answer is that it moves toward the home, you could have a problem.
Solution -- One of the ways to prevent moisture from getting into your house from this point and others like it is to do some landscaping. Bring a little extra top soil right into this area, build up the earth a little bit to create a more positive slope "away" from the house foundation. - If you have a deck behind your house, it could be hiding a low slope. Be sure to check underneath the deck to see if rain has come through and built up in the area. One of the things you'd want to do is to perform the same test with a bucket of water to make sure the flow is going away from the house and not toward it.
- The next area to check is your gutter system. Properly maintained gutters carry water away from the house. Be sure to check the gutters and downspouts every fall and spring (twice a year) to make sure they are moving water away properly. If the end of the downspout can't carry the water at least a couple of feet from the foundation, add an attachment, which can be found at any hardware store.
- The basement can be one of the major sources of mold problems. Make sure any drainage system is working properly. For example, if you have an air-conditioning unit in the basement, make sure it's tilted toward the direction of the drain. Same goes with a humidifier or dehumidifier. If the units aren't tilted properly, puddles can form, which in turn can create a mold problem.
- Drains aren't the only problem with basements, water can leak in from the outside. It's extremely important to make sure there are no open cracks. Also, note that concrete, since it's porous enough, can let water move through into the basement. The surface can become damp enough to allow mold to grow.
Solution -- It's hard to keep moisture from entering basement walls and slabs, so experts warn against placing mold-friendly products such as drywall and wood in direct contact with the foundation. Because basements can get humid, it's best to use a dehumidifier during warmer months. - Bathrooms are another major source of humidity in any house. The primary source is vapor: moisture getting into the air. This is where a bath vent is vital and handy because it exhausts outside.
Liquid moisture in the bathroom is a problem as well. This is where the shower and tub come into play. Often it's easy for seals to go ad or for things not to drain as properly as they should. The problem can become so bad that the whole floor has to be removed and replaced because the structure of the floor is actually eaten up by mold. Solution: Make sure you tub and shower are sealed properly. Replace warn caulk around the edge of the tub or shower. - The attic is next. This potential moisture-and-mold trouble spot has the added pressure of usually housing a heating or air-conditioning unit that service the house. Both can generate moisture off the cooling or heating coils. That moisture needs to drain properly. Safety pans are usually installed to catch any excess moisture. Make sure your unit(s) have one.
RESOURCES :
Environmental Protection Agency Information
EPA's Mold Guide
Indoor Air Quality Information Hotline: 800-438-4318
Safe Drinking Water Hotline: 800-426-4791
U. S. Environmental Protection Agency (Headquarters)
Washington, DC 20460
Phone: 202-260-2090
Website: www.epa.gov
Institute for Business & Home Safety Information
For a free (single) copy of the Institute for Business & Home Safety's (IBHS) new water-damage prevention guide ("Is Your Home Protected From Water Damage?"), call toll-free: 866-657-IBHS (4247).
OR
You can also find this guide and all IBHS disaster safety publications by clicking here.
Institute for Business & Home Safety
Tampa, FL 33617
Phone: 813-286-3400
Fax: 813-286-9960
Website: www.ibhs.org
Moisture Audit (Jim LaRue)
Moisture expert Jim LaRue created a "moisture audit," which is available by clicking here.
What Every Home Owner Needs to Know About Mold and What to Do About It
Model: 0071412905
Author: Vicki Lankarge
(March 28, 2003)
To order this title from Amazon, click here.
McGraw-Hill Companies
Website: www.mcgraw-hill.com
My House is Killing Me! The Home Guide for Families with Allergies and Asthma
Model: 0801867304
Author: Jeffery C. May
(October, 2001)
To order this title from Amazon, click here.
John Hopkins University Press
The Healthy House: How to Buy One, How to Build One, How to Cure a Sick One, 4th Edition
Model: 0963715690
Author: John Bower
(November, 2000)
To order this title from Amazon, click here.
Building Science Corporation Information (Mold Research)
Building Science Corp. is a Boston based architecture and building science consulting firm that is one of the leading providers of moisture and mold research information.
Building Science Corporation
Westford, MA 01886
Phone: 978-589-5100
Fax: 978-589-5103
Website: www.buildingscience.com
GUESTS :
Bob Thompson
Website: www.epa.gov
Engineer
Environmental Protection Agency
Information private
| 
)
)
)
)
)
