The primary function of the jointer is to create straight and square edges. It may also be used to make a variety of angle cuts, including squares, tapers, recesses and bevels. A jointer's parts may move out of place, so you need to know some simple techniques to adjust them. To adjust the jointer's fence, loosen the stop screw (figure A). Use an Allen wrench to loosen the screws on top of the wheels behind the fence. Loosening those screws will rotate the fence. Continue rotating until the fence is perpendicular to the blade. Use a framing square to ensure that the fence is at a perfect 90 degrees (figure B). Adjusting the jointer's infeed table will adjust the depth of the cut. Loosen the lever underneath the table to set it to the desired depth (figure C). To adjust the jointer's outfeed table, turn the knob underneath the table to adjust it up or down. Use a straightedge to make sure the outfeed table is even with the top of the blades (figure D). To adjust the blades, loosen the four screws above the blades. Move the blades to their correct positions, and tighten the screws.
| 
)
)
)
)
)
