HOME BUILDING Index
Custom Homes
Electrical Systems & Wiring
Garages, Basements & Attics
Heating & Cooling
Home Exterior
Doors & Windows
Gutters & Drainage
Landscaping
Patios, Decks & Outside Structures
Roofing
Walls
Other

Home Interior
Inspections & Codes
Insulation and Energy Efficiency
Plumbing
Rooms
Sewerage & Septic Systems
Site Preparation
Other

BEST OF HOME BUILDING
Best Built Zone
Home IQ
Heck of a Deck
Weekend Projects
Home Renovations
Be Your Own Contractor

SPONSOR LINKS

  • A Strong Foundation: More Footings Information
  • From "Blueprint for Home Building"
    episode DBHB-103


    In the first segment you found out that footings are concrete pads that distribute the weight of the entire house down into the ground. For the next step in the foundation process, you'll need to keep in mind what part of the country you live in.
    advertisement


    PHOTO

    Figure A
    PHOTO

    Figure B
    How Are Footings Protected?

    Typically the foundation is 2' to 3' in the ground, low enough and depending if you're in a frost area, below what's called the "frost line," which is the depth at which the earth will freeze and swell. The United States is laid out by certain areas where the frost line is already designated. If you aren't aware of the frost line in your area, this is the beauty of getting a building permit. Ideally a city will make you aware of the frost line and the requirements for your footings.

    If you're up in Maine and have a 40" or 42" frost line (figure A), this means the ground has the potential to freeze in the winter time 48" down. In Florida, for example, you won't need to dig down because the frost line there is 0.

    Note: For those of you living in colder climates, keep in mind that you're going to need to dig a bit deeper than usual in order to avoid the frost line.

    Of course, this extra depth is going to cost a bit more, but it's well worth it because placing footers above the frost line can cause the concrete to crack and shift, which means costly repairs -- and massive headaches!

    Moisture also is a primary concern in preserving the footings. The best way to keep moisture out is by applying a sealer (figure B) to the concrete. A sealer is a tar-like material that you apply to the footing and foundation. The coating "seals" out the moisture, protecting your footings for the life of your new home. This is the goal of any flat or horizontal surfaces -- to use a high-quality sealer to keep water from penetrating into the dried concrete.
    PHOTO

    It's a myth that you have to lay the foundation and footing in one day.
    Pouring the Concrete

    Some people may think that it's best to lay the foundation and footing in a single day, but this is "not" true. In fact, commercial jobs that multiple pours all the time because you aren't able to do everything in one day, so you have a design that allows for this multiple-pour process.

    Using quality suppliers enters into this picture. Many ready-mix operations utilize the same materials for the same type of pouring applications because it's virtually impossible to always do an entire job all in the same day.

    In the next segment host Jeff Wilson talks about the different kind of foundations that can be installed for your new home.


    GUESTS :

    Dave Watson
    Architect
    E-mail: dave@watsonarchitect.com
    Website: www.watsonarchitect.com

    Heinrich Klingner
    General Contractor
    Eurocraft Construction
    We apologize no contact information is available.

    Jody Cukier Siegler
    Interior Designer
    Siegler Design and Development LLC
    E-mail: jodycs@yahoo.com

  • ALSO IN THIS EPISODE: