Red Team Activity Journal (1 p.m. - 3 p.m.) - Pieces of 1 x 4 are connected to each side and front of the bar to serve as supports for the roof (figure A).
- The team continues paneling the corner frames and sides of their project with 1/2-inch plywood, then brings two pre-made cabinets and a refrigerator inside the bar.
- They also use plywood to make a shelf inside the main frame. The shelf is secured with nails and metal brackets.
- Three pieces of 1/2-inch plywood are cut for the countertops that are designed to stick several inches beyond the frame's edge (figure B). Once all are nailed to the main frame, a hole is cut and a sink dropped into place.
Ed's tip: A sink is a great addition to an outdoor patio bar and you often don't need a complicated system. If you only need cold water, you can just attach a garden hose to your sink and use a double supply stop. A double supply stop connects the hose to both faucets. You will need to connect a hose adapter to the valve on the supply stop when you install.
Blue Team Activity Journal (1 p.m. - 3 p.m.)
- The team measures, cuts and attaches 3/4-inch plywood for the bar's floor and sides.
- The plywood base of the larger section's countertop is covered with large stone tile. They also mix in the smaller tiles like those on the other section's countertop (figure C).
- After measuring and cutting oak 1 x 2s to trim out the bar, the team softens the edges with a router. The trim is attached to the edges of both countertops.
- While the countertop tile is being grouted, the Blue Team covers the front of the bar with faux brick sheeting and secures it with screws (figure D).
| 
)
)
)
)
