HOME IMPROVEMENT Index
Appliances
Basement
Bathrooms
Bedrooms
Cleaning
Contractors
Doors
Driveways & Paths
Duct Tape
Electrical Systems
Family Room
Fences & Gates
Fireplace
Floor Coverings
Furniture
Handles, Knobs & Hinges
Help on the Homefront
Home Energy Efficiency
Home Office
Homeowner in Process
House Exterior
Indoor Pests
Kitchens
Lighting
Outdoor Equipment
Outdoor Structures
Trellises & Arbors
Decks
Log Cabins
Maintenance
Other

Painting
Plumbing
Safety
Sports-Related Additions
Staining
Stairs
Storage
Tools
Utility Room
Walls & Ceilings
Windows

BEST OF
HOME IMPROVEMENT
Flooring
Decks
Mold Quiz
Home Safety
Tiling Techniques
Lighting Solutions
Weekend Projects
DIY to the Rescue
Home Renovations
Bathroom Makeover
Kitchen Renovations
Ultimate Media Room
Be Your Own Contractor

SPONSOR LINKS

  • Outdoor Kitchen: Counter Framing, Part 2
  • From "Build an Outdoor Kitchen"
    episode DBOK-101


    (Continued from page 1)

    • After the first two cabinet walls are built, you can attach the bottom shelf. Screw down one 2x2 to the bottom edge of each cabinet wall (figure H).

    • Insert the plywood shelf and brace the top of the cabinet with two 2x4's (figure I).
    Photo

    Figure H

    Photo

    Figure I


    advertisement


    • Flip the cabinet upside down and anchor a piece of composite lumber to the front edge (figure J). Then set the cabinet into place and shim up the bottom until it is level.

    • Once it's level, drive concrete screws into the bottom and into the patio to secure the cabinet (figure K).

    • Attach the unit to the back wall using 3-1/2 inch decking screws.
    Photo

    Figure J

    Photo

    Figure K


    • After building the first two components to house the stainless-steel cabinets and sink, follow the same procedure to build the cabinet units that will support the refrigerator, built-in grill and side burner (figure L).

    • When building the cabinet units, remember where the utilities will be. Using a hole saw and a spade drill-bit, cut the holes for the plumbing.

    • Be sure to cut out any openings on the faceplate (for cabinet doors and appliances) before installing. Using deck screws, attach the face of the cabinet (figure M).
    Photo

    Figure L

    Photo

    Figure M


  • In the segment that follows, backer board is added to help the cabinet unit withstand the elements of nature.

    Important: Included in this episode are the steps in this outdoor home-improvement project as shown in the episode. These steps are general guidelines that are applicable for similar construction projects. For any construction projects, there may be procedures, specifications, equipment, etc. that are specific to the specific site and circumstances. There may also variations according to the type and brand of materials you select. Always consult local building codes when undertaking significant home-improvement projects, and read and follow the manufacturer's directions and precautions that come with any materials, tools or equipment you decide to use.

    Next: Next: Counter Backer-Board


      1 | 2



    GUESTS :

    Christi Homar
    Christeel Design
    P.O. Box 5480
    Chattanooga, TN 37406

  • ALSO IN THIS EPISODE: