1. Begin by measuring each cabinet opening using a measuring tape and a five sixteenths of an inch spacer block (figure A). The spacer block gives you an opening dimension slightly smaller than the actual opening allowing the cut-down door to open and close easily.2. Record the measurement for each door and drawer. Use a table saw to cut the door down to the new measurements (figure B). In this example, it takes four passes for cut each to the proper size. Repeat for each drawer and door.
3. Next, it's time to create the lip molding frame to trim the edges of the cut-down cabinet doors. Measuring is critical in this step. Because of the contour of the lip-molding, mark the door where the miter needs to go, then transfer that mark to the corresponding spot on the lip molding. With the lip molding marked, cut to a 45-degree angle on the miter saw (figure C).
4. With the four sides of the frame mitered, attach the lip molding to the cabinet door first with a thin layer of glue, then secure with a nail gun (figure D).5. Use wood putty to fill in gap at the mitered corners and to fill in any nail holes. After the putty has dried, sand, prime and paint the cabinet doors (figure E).
)
)
)
)
)
