HOME IMPROVEMENT Index
Appliances
Basement
Bathrooms
Bedrooms
Cleaning
Contractors
Doors
Driveways & Paths
Duct Tape
Electrical Systems
Family Room
Fences & Gates
Fireplace
Floor Coverings
Furniture
Handles, Knobs & Hinges
Help on the Homefront
Home Energy Efficiency
Home Office
Homeowner in Process
House Exterior
Indoor Pests
Kitchens
Cabinets, Countertops & Hardware
Faucets & Fixtures
Remodeling

Lighting
Outdoor Equipment
Outdoor Structures
Painting
Plumbing
Safety
Sports-Related Additions
Staining
Stairs
Storage
Tools
Utility Room
Walls & Ceilings
Windows

BEST OF
HOME IMPROVEMENT
Flooring
Decks
Mold Quiz
Home Safety
Tiling Techniques
Lighting Solutions
Weekend Projects
DIY to the Rescue
Home Renovations
Bathroom Makeover
Kitchen Renovations
Ultimate Media Room
Be Your Own Contractor

SPONSOR LINKS

  • Turn-of-the-Century (1of 3): Removing the Trim and Old Flooring
  • From "Kitchen Renovations"
    episode DKTN-202


    PHOTO

    Paul Ryan, host of Kitchen Renovations, starts a three-part project to convert this out-of-date kitchen...
    PHOTO

    in a house that the homeowners are restoring ...
    PHOTO

    into an authentically recreated Victorian kitchen ...
    PHOTO

    complete with period appliances and ...
    PHOTO

    new counters!
    In this segment host Paul Ryan and the homeowners carefully remove the trim so it can be reused. The old tile backsplash is chipped away, and the vinyl floor is easily removed after it's cut with a circular saw.

    Materials and Tools:

    Appliance Removal--

    gloves, safety glasses, drill, appropriate screw head bit, pry bar dolly

    Removing Countertops--

    safety glasses, gloves, hammer, pry bar

    Trim and Base Removal--

    safety glasses, gloves, hammer, pry bar, pliers

    Flooring Removal--

    safety glasses, gloves, utility knife, circular saw, tape measure, hammer, pry bar, tape, scrapper, broom, vacuum, garbage bin, roofing shovel

    Prepping for Underlayment--

    mask, safety glasses, gloves, broom, rosin paper, hammer, tack hammer, utility knife, thinset mortar

    Installing Underlayment--

    safety glasses, pencil, 1/4"-high grade multi-ply plywood, tape measure, jig saw, table saw, pneumatic stapler, 1-1/4" galvanized staples

    Building Extending Wall--

    safety glasses, gloves, pencil, 2x6" material, tape measure, table saw, chop saw, impulse framing nailer, 3-1/2" nails

    Installing Drywall--

    1/2" drywall, 1-5/8" drywall screws, safety glasses, utility knife

    Prepping Sink Wall--

    safety glasses, mask, gloves pry bar hammer, 1/2" drywall, 2x4 material (for fire blocks)

    Installing Fire Blocks--

    safety glasses, 2x4 material, chop saw, jig saw, impulse framing nailer, 3" nails

    Closing-up Sink Wall--

    safety glasses, framing square, tape measure, pencil, utility knife, self-adhesive fiberglass tape, 1/2" drywall,
    1-1/4" dry wall screws, joint compound, mud pan, trowel, 5" mudding knife, sanding block, vacuum
    advertisement


    PHOTO

    Figure A
    PHOTO

    Figure B
    PHOTO

    Figure C
    Floor and Backsplash Removal

    1. Remove the shoe and base boards by using a small pry bar and hammer (figure A). Be careful because old wood can be brittle. You may want to reuse the trim.

    2. Remove the nails from the baseboard and the shoe. Do this using pliers, pulling the nails through the back of the boards.

    3. Remove the metal transition strips.

    4. While you have the hammer in hand, go ahead and remove the backsplash (figure B).

      Note: In this particular house, there were two layers of flooring (old vinyl and luan) that both had to come up.

    5. Make cuts through the existing floor. Set a circular saw at 3/8", just deep enough to go through vinyl and sub-floor. You will need to begin your cut with a plunge cut (figure C). Make cuts full length of the room, 3' to 4' apart.

      Tip: Use an "old" blade for this job since you'll probably be going through staples and other debris in the floor.

    6. To take out the vinyl flooring, score it with a utility knife in a few places going the other way. This will make it easier to discard. Simply roll back the pieces and throw away.

    7. Using pry bars, lift up the lip of the underlayment so you can get your fingers under it. Be careful when lifting because the underside will be full of staples.

    8. Once all of the underlayment is removed, go over the floor with a hammer, hammering down all staples sticking up.


    RESOURCES :

    Stanley Tools Information
    Stanley Tools/Works
    Website: www.stanleyworks.com

    Fiskars (Bucket Boss Division)
    Fiskars Bucket Boss Division
    Website: www.bucketboss.com

    Makita Products
    Makita USA Inc.
    Website: www.makita.com

    Paslode Nail Guns
    Paslode
    Website: www.paslode.com

    3M Painter's Masking Tape and Sanding Pad
    The 3M Company
    Website: www.3m.com

    Linoleum Floor Covering (Forbo Linoleum)

    Brand name: Marmoleum
    Model #s: 3830 and 3120
    Where available: See Forbo Linoleum information, below

    Miscellaneous Product Information:

    • Marmoleum is "not" vinyl. It's made from natural ingredients and it allergen-free.
    • The adhesives used to install Marmoleum are environmentally friendly.
    • There are 13 standard configurations and 100-plus colors in the design-it-yourself borders and corners.

    Forbo Linoleum
    Website: www.themarmoleumstore.com

    Dixmude, Wall-mount Faucet (Herbeau Creations)

    Brand name: Herbeau
    Model #: 420459
    Color: Weathered copper/brass
    Where available: At showrooms nationwide, and see Herbeau Creations information, below

    Herbeau Creations
    Website: www.herbeau.com


    GUESTS :

    Shane Kretsinger
    Vice President, Operations
    Autumn River
    We apologize no contact information is available.

    Terry Conlin
    Flooring expert
    Floor Design
    Website: www.floordesign.com

  • ALSO IN THIS EPISODE: