HOME IMPROVEMENT Index
Appliances
Basement
Bathrooms
Bedrooms
Cleaning
Contractors
Doors
Driveways & Paths
Duct Tape
Electrical Systems
Family Room
Fences & Gates
Fireplace
Floor Coverings
Furniture
Handles, Knobs & Hinges
Help on the Homefront
Home Energy Efficiency
Home Office
Homeowner in Process
House Exterior
Indoor Pests
Kitchens
Lighting
Outdoor Equipment
Outdoor Structures
Painting
Plumbing
Safety
Sports-Related Additions
Staining
Stairs
Storage
Tools
Utility Room
Walls & Ceilings
Windows

BEST OF
HOME IMPROVEMENT
Flooring
Decks
Mold Quiz
Home Safety
Tiling Techniques
Lighting Solutions
Weekend Projects
DIY to the Rescue
Home Renovations
Bathroom Makeover
Kitchen Renovations
Ultimate Media Room
Be Your Own Contractor

SPONSOR LINKS

  • Making the Room Workable
  • From "Weekend Decorating"
    episode WDC-105
    advertisement

    Click here to view a larger image.

    Figure A

    Click here to view a larger image.

    Figure B

    Click here to view a larger image.

    Figure C

    Click here to view a larger image.

    Figure D

    Click here to view a larger image.

    Figure E

    Click here to view a larger image.

    Figure F

    Click here to view a larger image.

    Figure G

    Click here to view a larger image.

    Figure H

    Click here to view a larger image.

    Figure I

    Click here to view a larger image.

    Figure J

    Click here to view a larger image.

    Figure K

    Click here to view a larger image.

    Figure L

    Click here to view a larger image.

    Figure M

    Once again, Golden turns to a sketch to help her with this project. This sketch is a drawing that will help her in organizing the shelving unit she plans to build on one wall (figure A).

    1. Drill a hole through the boards with a 2-3 /4" saw bit to allow for the galvanized pipes on either side of the shelving unit.

      Safety tip: Wear glasses or goggles.

    2. Attach a flange at both ends of the pipe, one to attach at the ceiling and one to attach at the floor. Running a smaller piece of pipe through the larger pipe can allow for play in height.

    3. Use a 1/4" all-purpose drill bit and drill a pin into the pipe for shelf supports (figure B).

    4. Make holes in the boards slightly larger in diameter than the galvanized pole to allow for play (figure C).

    5. Lay the longest board on the floor (figure D). Measure and mark for pipe placement.

    6. Stack the boards according to the sketch. An extra set of hands would be useful at this point.

    7. Slide the pole into position (figure E). Make sure the pole is level and mark for screw holes (figure F).

    8. Predrill (figure G) for screw holes and install anchors (figure H).

    9. Attach to ceiling and floor using flange (figure I).

    10. Continue to measure and mark for shelf placement (figure J). The arrangement can vary depending on personal taste.

    11. Drill holes through pipe for shelf-support pins and position shelves in place (figure K).

      Note: Drilling more holes into the pipe will give more options later when adjusting the shelf height.

    12. Once shelf height is achieved, push the pins through pole (figure L).

    13. If planning to paint the shelves, woodworking expert John Ferguson suggests choosing finger-jointed poplar as poplar mills well and gives a crisp detail.

    14. To utilize the wall space, Golden attaches a preassembled birch tower in the same way as she attached the hollow-core door to the walls. Using L-brackets, which were drilled into the wall studs, lay the tower horizontally across the brackets. What began as a storage closet has now begun its transformation to a usable office (figure M).

  • ALSO IN THIS EPISODE: