DIY Network

Log Cabin Bedroom: Installing New Pine Trim (Doors and Windows) From "Weekend Remodeling" episode WKR-311

If you're looking for a rustic style that says "all boy" -- or maybe even a cabin feel for your own bedroom or family room -- here's a project from host Fuad Reveiz to make that happen! Here, Reveiz will walk you through adding trim, installing log siding and building custom shelves to show off boyhood treasures.

On a 1-5 intermediate remodeling scale, this project ranks 1 in difficulty.
This project can be completed in 16 hours over 2 days.

advertisement

	This basic blue boy's room will become ...
	... a log cabin retreat!

Materials:

Log siding
1 x 6 pine lumber
1 x 4 fluted casing
4 x 4 pine post
Pry bar
Tape measure
Level
Chalk line
Large felt tip marker
Reciprocating saw
Hammer
Utility knife
Circular saw
Chop saw
Table saw
Drill
Framing square
Framing nailer
1" Forstner bit
Trim nailer
Safety glasses
Polyurethane
Trim nails
Wood screws
Wood bit
Stud finder
Torpedo level

	Figure A
	Figure B

Before beginning: Apply polyurethane to trim and 2 x 4 stock.

1. Begin by removing all existing moldings. Score the top of the baseboards using a utility knife. This will break the paint seal and any caulk. Use a pry bar and hammer to remove the baseboards. Next, use the pry bar to remove any decorative trim near the ceiling.

2. Move on to the window trim. Score the caulk joint around the window sill, and slide the sill right out. This sill will be replaced with a wood sill that matches the room. Finally, remove the casing from around the doors.

3. Normally, the new trim work would be completed after all other work. But in this case, the trim work is done first so that the log siding will butt against it. To begin the trim work, first measure inside dimensions of window. Measure the width and depth of the window sill and sides.

4. Next, cut 1 x 6 pine to length, the rip to depth needed. Set window sill into position first. Attach with 2-1/4" trim nails (figure A). Place the top sill in the window. Next, kset the two sides in and wrap the interior of the window.

5. Measure the outer dimensions of the window, then cut decorative 1 x 4 fluted casing on the chop saw. Align with the window sill, leaving a 1/4" reveal, and nail in place.

6. Measure and cut the side pieces and attach the same way. At the top, carefully align the mitered corners and nail in place. For extra support, nail into the sides of the trim where the corners meet (figure B).

7. Add the door trim. First measure for the length of the inside corner piece, then measure for the width. Cut to length, then rip on the table saw to the correct width.

8. Attach the trim to closet door frame using the trim nailer. With both sides up, measure for the top piece, cut and nail in place. Finally, cut and nail the entry door trim in place.