DIY Network

The Right Way to Plant a Tree Healthy roots and cultivating the surrounding soil are keys to success in planting a new tree. From "Dirt On Gardening" episode DDOG-110

(Continued from page 1)

	Figure A
	Figure B
	Figure C
	Figure D
	Figure E
	Figure F

Planting Technique

Here are the basics steps for planting your tree "pedestal style" as shown in the demonstration.

Important: Before you dig, make sure that the spot you've chosen for your tree does not have any underground lines that would endanger you while planting.

• According to Gabe Beeler, a common mistake when planting a tree is to simply dig a large hole and add amended soil into the whole. This tends to cause a "container effect" on the tree's roots as they grow to the edge of the amended soil then begin girdling around the perimeter of the space. This can ultimately lead to the tree falling over in a high wind because the tree hasn't been able to properly anchor itself with its roots. A better technique is to break up or cultivate the soil in a circular area around the location where the tree is to be planted. First, dig a whole that's the depth and diameter of the plant's container (figure A). Remove and discard grass and weeds from the planting site. Then break up and the soil around the hole so that it's loose.

• With the hole dug and the soil around the hole thoroughly cultivated, carefully remove the tree's root ball from its container, and using your hands, gently loosen any outside roots from the sides and bottom, taking care not to break or damage the root ball (figure B).

• Place the tree in the center of the hole on the undisturbed pedestal so the root crown (where the trunk meets the roots) is about 1-1/2 to 2 inches above the surrounding ground level (figure C).

• If your tree came tied to a nursery stake (figure D), remove the stake. Another common mistake, according to Beeler, is over-staking trees. If your tree is sturdy enough to hold itself upright, do not re-stake it. If the tree needs help to stand upright, use two stakes and ties. Place the stakes on opposite sides of the tree, planted outside the area you just cultivated, approximately 18 inches from the trunk. Place tree tape loosely around the trunk and attached to the stakes with ties. The ties should be loose enough to allow the tree to move back and forth slightly in high wind.

• Backfill the hole with the soil you removed. Discard any grass and weeds from the soil. Do not add soil amendments.

• Finish backfilling the hole, but remember not to cover the top of the root ball, which is the root crown stake. Create a circular berm around the base of the tree to help contain water and channel it to the tree's roots (figures E and F).

• Water thoroughly right after planting, soaking the planting area. This will help get the roots established and settle the soil

• Spread mulch or wood chips about 6 inches deep over the entire planting area, leaving a bare four to six inch area directly around the trunk.

• If you did have to stake your tree, periodically check the stakes and ties to ensure that they are not harming the trunk or branches. The tree should be able to stand on its own after one year.

advertisement

Tree Survival Tips: What to Avoid

Here are two of the more common situations that cause newly planted tree saplings not tp survive--and tips for avoiding each problem.

• Drowning. Check root moisture for newly planted trees. Don't be fooled by surface soil conditions: check the soil four to six inches deep. The soil should be moist, not soggy. One effective means for watering, and one which wastes less water than using sprinklers, is to place the end of hose against the trunk and let the water drip all day or night.

• Suffocation. Avoid planting too deeply. The root crown (where trunk meets the roots) should be 1-1/2 inches to 2 inches above ground level.

1 | 2

GUESTS :
Gabe Beeler
Board-certified master arborist
Fallen Leaf Tree Service