 |
| Rain Barrel, Creating a |
| This DIY Basic, brought to you by The Home Depot, will provide tips on creating a rain barrel. |
|
advertisement
|
By positioning rain barrels under downspouts (figure A) you can collect enough run-off to significantly cut your outdoor watering bill.
- A fifty-five gallon plastic drum with an intake hole cut in the top will work well.
- Creating a drainage hole toward the top of the barrel will enable overflow water to escape.
- A hole toward the bottom will allow you to drain captured water for use around your home.
- The male parts of faucet assemblies fitted with rubber washers can be inserted from the inside of the barrel (figure B) and the faucet fixtures can be threaded on from the outside.
- A screen filter will prevent gutter debris from entering your barrel (figure C).
- By modifying your downspout you can attach an extender tube and feed it through a filter that sits in the top hole (figure D).
- A screen filter will prevent gutter debris from entering your barrel and the water will flow best from the barrel if it is raised off the ground (figure E).
- By creating several rain barrels you can save enough water to help you get through the hot and dry summer months.
Web Extras
- The size of the hole you cut in the top will be determined by the size of the filter basket you plan to use. Allow enough room for the baskets lip to rest on top of the barrel so it wont fall in. The diameter should be large enough to accommodate the downspout extender tube.
- By drilling a starter hole, you can slip the blade of a jigsaw in more easily.
- Placing a rubber washer on the inside piece will ensure a watertight seal.
- Use a 1 1/8-inch spade bit to create the bottom and top drain holes.
- To modify the downspout, separate sections of the downspout or cut it with a hacksaw. Attach a 90-degree downspout elbow and then the plastic extender pipe.
- Use a plastic or nylon screen so it doesnt rust.
RESOURCES :
The Home Depot Information
Website: www.homedepot.com
|