DIY Network

Photo Locket Pendant Photo Locket Pendant From "Jewelry Making" episode DJMK-312

Locket Pendant

Materials:

Glass medical slides
Copper tape
22-gauge copper wire
Solder
Small photo or image
Bleach
Antiquing medium
Antique brass chain
Antique brass charms
Antique brass jump rings and clasp
Craft knife
Soldering gun
Wire-cutters
Round-nose pliers
Chain-nose pliers

advertisement

	Figure A
	Figure B

1. Lay one slide on top of the image and trim the image (figure A) to fit the slide.

2. Sandwich the image between two slides and wrap the edges with copper tape.

3. Attach a copper-wire jump ring to act as a pendant bail and attach with copper tape (figure B).

4. Solder the exterior of the copper to make the seal permanent and silvery in appearance.

5. Attach the pendant to the chain necklace and add charms.