DIY Network

Eclipse Slick-Finish: Introduction and Getting Started Removing the Interior Door and Dash Panels From "Tricked Out" episode DTRK-302

The project car: 1999 Mitsubishi Eclipse RS

In this project Andrew Totolos, host of DIY's Tricked Out, tricks out the interior on a 1999 Mitsubishi Eclipse RS. The interior is well designed but it needs some flash, so Andrew removes both door panels and all of the lower dash panels to give them a new look. First the panels are smoothed with multiple grades of sandpaper. In this first phase of the project, Andrew introduces the project car and readies the car for modification.

advertisement

Materials used in this project

In addition to standard auto-mechanic's tools (wrenches, ratchets, extenders, screwdrivers, nut-drivers, torque wrench, etc.), tools and materials used in this episode include:

dentist's pick
cleaning supplies
sandpaper
paint supplies
mixing containers
air sprayer
air compressor
pop-up tent
plastic sheeting
scissors
tape
box fan
air filter
respirator
dash face gauge kit
standard shop tools, including screwdriver
dentist's pick
power sander
safety goggles and gloves
eyelet connectors
fuse taps
wire ties

The Eclipse interior before the upgrade

Important: Included in this summary are the steps in this automotive procedure as shown in the episode. These steps are general guidelines that are applicable to most vehicles. With any particular car or truck, there may be procedures, specifications, settings, tolerances, components, etc. that are specific to that vehicle. There are also variations according to the type and brand of upgrade-kit you select. Always consult your vehicle's service manual when undertaking significant automotive repairs, and read and follow the manufacturer's directions and precautions that come with your kit or replacement parts.

Safety Alert: Always wear eye protection and ear protection, and follow proper safety precautions, when working with power tools or pneumatic tools. Also wear eye protection any time you are working underneath a vehicle.

Safety Alert: As a standard safety precaution, always disconnect the vehicle's negative battery cable before you begin work on any electrical or mechanical components.

Page  1 | 2