| '48 Indian Motorcycle: Finishing Touches |
From "Classic Rides"
episode DCLR-310 |
|
|
(Continued from page )
It's time for some accessories. We've got shiny new emblems for the tanks and a "Hollywood" Bar, which is a crossbar for the handlebars.
Emblems Application- The process for these two items is pretty simple and definitely pretty easy. We'll do the emblems first.
- Dry fit the emblems and place a piece of tape along the lower edge to make their place.
- Do the same with the other side and check that the two sides are level.
- Peel off the backing from the sticker side, and press the emblem firmly onto the tank.
- Repeat this process with the other side.
Hollywood BarThe Hollywood bar will go on next. This bar connects the two sides of the handlebar, and although may act as a stiffener, its main purpose is cosmetic. Set the bar in place, so each end sits against the handlebar. Then using the clamps provided, place one on each side so it goes around the bar of the handlebar. Pass a bolt through the one side of the clamp, the end of the Hollywood bar, and then the other side of the clamp. Put a lock nut on the end of the bolt and tighten with a wrench.Check that the Hollywood bar is even and make any adjustments that are needed.
| ALSO IN THIS EPISODE: | | '48 Indian Motorcycle: Finishing Touches |
| 
![PHOTO](javascript:popup("http://img.diynetwork.com/DIY/2007/02/23/dclr310_2ca_Indian_Decals_e.jpg",350,450))
![PHOTO](javascript:popup("http://img.diynetwork.com/DIY/2007/02/23/dclr310_FINALd_horiz3_e.jpg",350,450))
![PHOTO](javascript:popup("http://img.diynetwork.com/DIY/2007/02/23/dclr310_FINALe_horiz_rear_e.jpg",350,450))
